This is the top HH motor in the market today.  It is one of the most solid motors we have seen so far.  High quality and excellent performance.  Works with all DiSEqC 1.2, 1.3,  USALS or "Goto X" compliant receivers.

 

Once the satellite positions have been programmed in the system, the STAB HH Motor returns the dish to exactly the correct location when you switch channels. Max intelligence precision calibration allows the motor to go to the satellite accurately every time.

 

Made in Italy

See Tele-Sat magazine report about this motor here!

• Maximum precision

• Mechanical robustness

• Connection without external feeding, only by coaxial cable

• Reduced dimensions

• Maximum easiness of installation

The principal of a motorized system is that the dish moves from east to west to track the satellites positioned along the Clarke belt.

This is a DiSEqC 1.2 and USALS compliant motor mount. It utilizes a data stream passed up the LNB co-axial lead to the mount. Only one co-axial cable (the one that goes to the LNBF) is needed for installation.

Tighten all the coaxial cable connections only by hand. Using a wrench may over-tighten the connections, causing damage. Such damage is not covered by the Limited warranty.

• Mounts on Pole Size up to 2 5/8"

• Standard Shaft Size: 2 1/8" (54mm) shaft diameter to fit most dishes with U-Bolt Bracket.

No extra lines needed.  HH Motor gets its power and signal from the

same RG6 coaxial cable going to the LNBF.