Home > HH Motors > SG-2100

DiSEqC  Compatible MOTOR

Sadoun Digipower SG2100

Sold Out See Sadoun PowerTech line of motors here!

With a motorized system the dish moves from east to west to track the satellites positioned along the Clarke belt.  Good for any offset dish with a U-bolt or Pole mounting up to 120 cm Aluminum or 95 cm Steel. This motor will fit a Winegard 30" dish.

Works with all DiSEqC 1.2, 1.3,  Goto X compliant receivers. It utilizes a data stream passed up the LNB co-axial lead to the mount. Only one co-axial cable is needed for installation.

Warranty: 1 year manufacturer's warranty serviced by us.  We only service Digipower SG2100 motor that has our sticker on it and with dated receipt.

FEATURE:

• Special design for any receiver with DiSEqC 1.2 control

• Does NOT require a receiver with built-in Positioner

• Only one coaxial cable control

• Go to X function

• High efficiency

• Compact structure

• Ultra low noise

• Ball bearings

• Adjustable hardware limits

• Easy installation with LED Indicator

• Built-in manual One button for EAST / WEST movement

• For any dish up to 1.2M (LESS THAN 27 LBS)

• Works with the Fortec Star dish and all other dishes like the Winegard, KTI, Patriot, and off brands.

• Mounts on Pole Size up to 2.5"

• Standard Shaft Size: 1 5/8" (42mm) Small shaft diameter to fit most dishes.

• Optional Shaft Size:  2" (50mm) Shaft to Fit Bigger dishes with U-Bolt brackets.

1 5/8" (42mm) Small shaft diameter to fit most dishes.

 

Specification:
Model	SG2100
Antenna Diameter	120 cm Aluminum or 95 cm Steel
Azimuth Angle	75˚EAST ~ 75˚WEST ( 150˚ ) Adjustable
Elevation Angle	10˚~75˚
Shaft Diameter	1 5/8"  (42mm)
Input / Output Voltage	13 / 18 VDC
Power Consumption	50 mA ( Standby mode )                        200mA ( Normal)                       350 mA ( Max.)
Rotation Speed	1.9˚ / sec ( at 13V) ; 2.5 ˚/ sec ( at 18V)
Satellite Positions	60
Connector	F Type
Command Protocol	DiSEqC 1.2
Resynchronize Function	YES
Goto Position 0 Function	YES
Goto X Function	YES
Positioning Sensor	Hall Effect Sensor
EAST / WEST Limit	Adjustable Hardware and Programmable Software
Manual Button	EAST / WEST

1 Year Mfg Warranty

NOTE: Tighten all the coaxial cable connections only by hand. Using a wrench may over-tighten the connections, causing damage. Such damage is not covered by the Limited warranty.

No extra lines needed.  HH Motor gets its power and signal from the

same RG6 coaxial cable going to the LNBF.

 

	Replacement Motor (with Worm Gear) for Sg2100 Motor with Worm Gear for SG2100 Motor $39
	Replacement Brackets (with U-Bolts) for Sg2100 BracketKit for SG2100 Motor $29
	SG2100 42mm Replacement Tube 42mm Tube for SG2100 Motor $12.99
	SG2100 50mm Replacement Tube: Use this tube if you are going to use a big dish over 95cm. 50mm Tube for SG2100 Motor $12.99