PowerTechREGULAR LINEAR ACTUATOR Arm Dish Mover (TD) 24" stroke length 24v Standard Duty Actuator for use with C Band or KU Band (Prime Focus) Dishes up to 6'
Price: $89
FEATURE: Adjustable Limit Switches Up to 3000N Static Load Reed Switch Sensor
Pulses per inch = 48 Corrosion Resistant Can be used on solar panels as a solar panel motor for automatic sun tracking.
Actuator Weight: 11 lbs
Specification:
Model
REGULAR ACTUATOR(TD)
Input
24VDC
Load Capacity
3000N
Stroke Length
600mm, 24"
Drive
ACME
Full Load Speed
4.2mm / sec
Duty Cycle
20%
Temperature
-26˚C~65˚C(-15˚F~150˚F)
Limit Switch
Adjustable
Sensor
Reed Switch Sensor
Static Load
3000N
Wiring The Actuator (wires not included with actuator):
The actuator line is comprised of five stranded copper wires.
Two 12 or 14 gauge stranded wires are used to power the motor and
Two color-coded 18 or 22 gauge shielded wires connect to the sensor.
These actuator wires should be connected to the appropriate terminals on the back of the receiver (or a separate actuator power supply).
Like the servo motor wires, the Two shielded motor sensor wires provide pulse, and ground. The vast majority of actuator motors do not require power to be hooked to the sensor. Look inside the actuator housing. If there are only two wires connected to the sensor, then hook up pulse and ground to their respective terminals. IF there are three wires connected to the sensor, and pulse and ground interchangeably to the other two sensor wires, then use 3 wires.
The two large stranded wires connect to the large wire terminals at the actuator motor and to the motor wire "M1" and "M2" terminals on the back of the receiver or actuator controller. Now try to move the dish to the east or west; if the dish moves in the direction opposite to the on intended, reverse the wires connected to the motor wire "M1" and "M2" terminals.
Adjustable Limit Switches
