Home > Installation Supplies > Mounts & Tripods

Tripods

• Molded heavy-duty ABS flat base

• Convenient azimuth degree markings

• Works with standard 18” satellite antenna and mount

• Includes: flat base, 18" satellite dish pole, detachable legs, ground anchor / bungee, compass and level

• Recommended for portable/travel applications

• Not recommended for permanent installations and dishes over 20" in diameter.

$39

MT3TRIPOD: 3Ft Self-Supporting Antenna Tower:

3' Tripod

If you have a balcony or porch, you could use this satellite dish tower to mount your dish.  You could also use it on the roof. Also used by Motor home and RV satellite subscribers. Recommended for satellite dishes up to 36" in diameter.  Uses 1 5/8" dia mast (not included)

$22

PVTP3KIT 3Ft Self-Supporting Antenna Tower 28" Mast:

3' Tripod with 24" Mast

If you have a balcony or porch, you could use this satellite dish tower to mount your dish.  You could also use it on the roof. Also used by Motor home and RV satellite subscribers.  Includes 28"x 1 5/8" dia mast. Recommended for satellite dishes up to 36" in diameter

$34

more info

If you have a balcony or porch, your could use this satellite dish tower to mount your dish. You could also use it on the roof.  Also used by Motor home dish subscribers. Mast not included. Good for satellite dishes up to 36" in diameter. Uses 1 5/8" dia mast (not included)

more info

Use it to attach a 1 5/16" dia mast to your existing DirecTV or DishNetwork dish.  Also works with Fortec Star 80P & 90P dishes.

• Includes mount, 2x support struts, and anchor screws. 

• Good replacement for your old roof/wall mount. 

• 1 5/8" mast diameter. 

• Works with most KU band satellite dishes from 18" to 36". 

• Use it on your horizontal or vertical Patio / Deck / Wall.

• Can be used on slanted roof

• Recommended for motorized dishes

• Wholesale quantity available

• Includes mount, 2x support struts, and anchor screws. 
• Good replacement for your old roof/wall mount. 
• 1 5/8" mast diameter. 
• Works with most KU band satellite dishes from 18" to 36". 
• Use it on your horizontal or vertical Patio / Deck / Wall.
• Not recommended for slanted. 
• Not recommended for motorized dishes
• Wholesale quantity available

Clearance

• Use it for any satellite dish that requires a 1 5/8" pole diameter. 
• Excellent choice for 18" to 39" dishes.
• Use it on your Patio / Deck / Wall / or Roof.
• Includes mast, foot base, and  2x supporting side struts.
• It can handle the slanted roof and should produce a plumb pole. 
• Make sure the slanted roof is facing South and the dish must clear the roof when it rotates East/West
• Good for stationary or motorized dish installations.
• Hole spacing in the base is 3.75" x 6" between centers.

$35

DS-3000 38 Inch J-Mount for DBS Satellite Dish / Outdoor TV Antenna (DS3000)

• Gray Color
• 1 5/8" Outside Diameter Pipe
• Wall thickness is 0.060"
• Use mount foot on either end of pipe
• Designed for outdoor antennas
• Galvanized steel
• 38" Long
• Use on side of house or roof

• Use it for SuperDISH, or any other satellite dish with 2" pole diameter requirement. 
• Excellent choice for 100 or 120cm dishes.
• Use it on your Patio / Deck / Wall / or Roof.
• Includes mount, 2x supporting side struts.
• It can handle the slanted roof and should produce a plumb pole. 
• Make sure the slanted roof is facing South and the dish must clear the roof when it rotates East/West
• Good for stationary or motorized dish installations.
• Hole spacing in the base is 5" x 7" between centers.

OUT OF STOCK

SB8051-DBL

Fits double 5/8 lap 4" siding with outside dimensions: 10x7

SB8053-DBL

Fits 1/2 or 5/8 lap 5" siding with outside dimensions: 12x8

SB8054-DBL

Fits Dutch lap siding with outside dimensions: 12x8

JVI 65-TMK1 Roof Tar Patch Kit

• Used for making waterproof attachments to roofs.

• Tar patches act as a waterproof sealant.

Each Kit Contains:

• Three 1” x 3 3/4” Pitch Patches

• Six Slotted Hex Head Lag Screws 1/4” x 2”

65-BT12 JVI PLYSEAL BISHOP

Permanently Seal and Protect Sub-Surface or Overhead Low Voltage Electrical. Use under antenna mounting hardware before bolting it down.

SIZE: 1 1/2" WIDE x 1/8" THICK x 30' LONG

Non Penetrating Roof Mounts

Uses 6 standard size cement blocks (block are not included)

more info

NPR4A: 3' x 3' Base Non-Penetrating Roof Mount

Uses 8 standard size cement blocks (block are not included)

more info

NPRMAT1 36" x 24" x 1/8" Neoprene Pad for Non-Penetrating Roof Mount 
 

NPRMAT2 36" x 36" x 1/8" Neoprene Pad for NPR4A Non-Penetrating Roof Mount 
 

Misc Brackets

• Supports dishes 18”- 36” offering exceptional strength and adjustability
• Easily install, remove, and upgrade satellite dish or antennas
• Prevents damage to roof/siding
• Available in Black or Brown

• Supports dishes 18”- 36” offering exceptional strength and adjustability
• Easily install, remove, and upgrade satellite dish or antennas
• Prevents damage to roof/siding

75-PSA2  Quick Pole / Pipe Adapter

1 5/8" OD, 8" long

Adapts mounting poles to DBS satellite dishes. Heavy gauge steel. Fits  Existing dish mounting poles.  Allows for quick and easy mounting of your FTA, Dish Network or DirecTV satellite dish onto your existing unused dish pole. Simply slip adapter over existing pole and tighten, then place your  new dish on the adapter. Also ideal for mounting to rooftop vent pipes.